June 1 (Johannesburg): 2023 Learning Indaba Conference.May 3-4 (London): Learning Technologies.If you have additional tips, feel free to share them in the comments section. If you have issues with low recording volumes, hopefully these tips help. Some of those filters may help fix the issues. In fact, many of us record in less than ideal circumstances where we may have background noises like air conditioners or computer fans. It’s probably worth learning a little more about some of the filters and how they can improve your audio input. The YouTube tutorial above does a great job showing the basics. Below are some resources to help you get set-up. Once it’s set, you really shouldn’t have to do much with it. Don’t let all of the meters and lines make it seem complicated. However, the installation is easy, and the setup is pretty simple. I’m no audio engineer or APO Equalizer pro. In addition, there are some other audio options to enhance your audio input and outputs. It’s an open source project on Source Forge that includes a pre-amp which will boost your incoming microphone signal. However, with the latest version of Windows 10, I just can’t seem to boost the input levels and there no longer seems to be a way to do it from the drivers or the audio control panel. In fact, on older versions of Windows, the Scarlett worked perfectly. Both Focusrite devices are good devices and should work. The range was limited to 8 to 10 with little room for adjustments. It has its own power source and not pulling it from the computer via USB. Since it’s a USB pre-amp, I figured that perhaps it just didn’t have enough juice for the phantom power and signal boost since it was pulling its power from the computer. I just wasn’t getting enough initial boost and the 8 to 10 range didn’t give me enough wiggle room. The pre-amp has an input range of 1 to 10, but it only seemed to have an impact from about 8 to 10. I have an older Focusrite Scarlett 2i2 which is generally simple to use and should work. If you do not have the option to boost your audio input, one potential fix is to select the Advanced tab from the Microphone Properties window and deselect the option to “Allow application to take executive control of this device.” This works for some people. However, in recent versions, there’s no option. Earlier versions of Windows had a way to boost the recording input, as seen in the image below. Like many Windows 10 users, the audio recording input signal is too low. However, it is an XLR mic which requires a different connection to my computer and a pre-amplifier.Īnd this is where the Windows 10 audio issue is exposed and fixed. It’s a bit higher end but it’s a great mic with a nice sound. However, the audio is a bit thin and sounds like I’m Lionel Richie on a phone, checking to see who’s home.īecause of this, I recently purchased a Beyerdynamic headset mic. It does a great job recording my voice and blocking out the other home office sound. However, webinars are live and I have less real-time control.įor webinars I prefer to use a headset mic because they seem to do a better job blocking out background noise. However, the challenge with the Blue Yeti is that I work from a home office and if people outside my office are yacking, then the mic picks up their chatter. I also like that the microphone has its own gain controls which resolves the issue I have below. Overall, I really like the quality of the sound and this set up works great for recording tutorials where I work from my main screen. With that comes the quest to find decent quality audio. I have a boom arm on my desk that I can swing into action. If you find that you’re microphone audio levels are too low, here are some tips that may help.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |